11-19 Ford Police Interceptor Utility (PIU)

This cap is designed to conceal holes in body panels that were cut by the police department when installing police equipment. The design is intende...

About This is version 1 (V1) of the Interceptor Shifter Filler Pocket. This version mounts from the top and does not require any disassembly of you...

About Fits 2011-2017 Ford Explorer and Police Interceptor Utility Vehicles. Optional laser-cut rubber liner mat available for purchase.For use with...

This filler panel is designed to directly replace the rear temperature controller when installing a center console in your Police Interceptor Utili...

This kit is intended for 2013-2019 Ford Police Interceptor Utility vehicles with the factory rear door interior trim panels. The OEM panel has a so...

This custom laser-cut rubber mat is made to cover the factory tray above the radio (Part Number: DB5Z-7806202-AA) in the center of the dashboard. P...

Before purchasing, be sure to check which angle/size your current headliner cut-out has. See photos for guidance.  This dome lamp assembly is an up...

This kit fits 2011-2015 Ford Explorer and 2013-2019 Ford Police Interceptor Utility. Will not fit 2016-2019 Explorers (Non Interceptor) as the door...

This is Version 1 (V1) of the original phone mount. V2 can be found HERE. This kit is designed for use with Ford Police Interceptor Utility vehicle...

These kits are designed to mount an aftermarket backup camera monitor (not included). They utilize the upped dash tray mounting screw to secure the...

This LED ambient lighting kit fits into the factory center console panel on 2011-2019 Ford Explorers. The color is Ice Blue to match the rest of th...

About Fits 2011-2019 Ford Explorer and Police Interceptor Utility Vehicles. For use with Explorer center console install/swap on vehicles that do n...

This is Version 2 (V2) of the original phone mount. V1 can be found HERE. V2 is mounted from the underside of the center console panel which create...

About This is version 2 (V2) of the Interceptor Shifter Filler Switch Panel. Version 1 can be found HERE. Unlike V1, this pocket mounts from the un...

About This is version 2 (V2) of the Interceptor Shifter Filler Pocket. Version 1 can be found HERE. Unlike V1, this pocket mounts from the undersid...

This custom panel fits inside the aftermarket plastic overhead headliner tray (not included) that is often times installed from the up-fitters for ...

About This is Version 1 (V1). Version 2 is available HERE. Version 1 mounts from the topside of the center console trim panel. Fits 2013-2019 Ford ...

This delete panel is designed for fill the hole where the power-lift tailgate and "TOW" (Part Number BB5T-13D734-CCW) buttons normally would go. Wh...